MENU
Important announcement – End of support information for Graphtec Pro Studio / Plus, Cutting Master 4 MORE
  1. HOME
  2. Download
  3. Firmware for CE6000 PLUS series download

Firmware for CE6000 PLUS series download

Software License Agreement

It is required to review the following license agreement before the software is downloaded. We will be deemed that the customer has to agree to the terms and conditions of the license agreement when the software had been downloaded by the customer. Please note that it is not possible to download or use the software if the customer does not agree to it.

GRAPHTEC SOFTWARE LICENSE AGREEMENT (GSLA)

Downloading Files

Ver.1.40 (Latest version)

Date of updated16 Feb, 2022
Supported ProductsCE6000-40 PLUS / CE6000-60 PLUS / CE6000-120 PLUS
Supported OSWindows 11 / 10
Downloading filesSoftwareCE6000Plus_FU(v140).zip (3,304KB)
  • The plotter driver must be installed for use.
  • Please read the update instructions carefully before completing the firmware update.
    If the update is not performed according to the procedure, the cutting plotter may not start.

Revision History

Ver.1.40

  1. Fixed the problem that the beeping sound continues when moving the tool carriage with position keys.
  2. Fixed the problem that the key becomes unresponsive when pressing the PAUSE key while scanning the Multiple registration marks.

Ver.1.21

  1. Increased the cutting speed of straight lines over multiple segments in the data of segmented area registration marks.
  2. Fixed the problem that caused extra feed after finishing cutting when cutting data with matrix registration marks and the media feed is being set.
  3. Fixed the problem that a scanning error occurs when scanning black and white inverted segment area registration marks TYPE 1.
  4. Fixed the problem that an error occurs when exiting from MENU after canceling the data which has rotated in the driver setting by pressing the PAUSE key and re-sending the cutting data while MENU is displayed.
  5. Fixed the problem that the only first vector was not cut by the set cutting pressure in the following combinations.
    ・Turn on the panel cutting.
    ・The cut data contains a command to change the CONDITION No.

Ver.1.10

  1. Supported Auto Sheet Feeder Unit F-MARK.

Ver.1.00

  1. First edition