MENU
Important announcement – End of support information for Graphtec Pro Studio / Plus, Cutting Master 4 MORE
  1. HOME
  2. Download
  3. Firmware for CE8000 series download

Firmware for CE8000 series download

Software License Agreement

It is required to review the following license agreement before the software is downloaded. We will be deemed that the customer has to agree to the terms and conditions of the license agreement when the software had been downloaded by the customer. Please note that it is not possible to download or use the software if the customer does not agree to it.

GRAPHTEC SOFTWARE LICENSE AGREEMENT (GSLA)

Downloading Files

Ver.1.11 (Latest version)

Date of updated03 Dec, 2024
Supported ProductsCE8000-40 / CE8000-60 / CE8000-130
Supported OSWindows 11 / 10
Downloading filesSoftwareCE8000_FU(v111).zip (3,649KB)
  • The plotter driver is required to be installed for use.
  • Please update the firmware according to the instructions to start cutting plotter properly.

Revision History

Ver.1.11

  1. Supported CE8000-40+ASF1.
  2. Fixed the problem that the cutting goes out of alignment in X direction with cut data with registration marks.
  3. Fixed the problem that the Media Set Assist did not work when Media Change mode is activated.

Ver.1.10

  1. Fixed the problem that the WLAN MODULE ERROR would occur if the cut data size is large when using WLAN.
  2. Updated not to overwrite the error message “WLAN MODULE ERROR” with the other errors.
  3. Fixed the problem that the page count was incorrect when operating continuous cut.
  4. Fixed the problem that the CUT CONDITION was selectable when a barcode scan error occurred in a large data.
  5. Fixed the problem that the [X motor signal] test and [Y motor signal] test in the Self Diagnostic Test were not displayed correctly.
  6. Fixed the problem that the touch screen was activated during the key test of Self Diagnostic Test.

Ver.1.03

  1. Fixed the problem that the position error occurs when retrying to read registration marks.
  2. Fixed the problem that the display could not be operated when connected to Data Link Server for a long period of time via wireless LAN.
  3. Fixed the problem that unnecessary retry operations were performed automatically when there was an error in reading registration marks.
  4. Fixed the problem that the key did not work during the buffer clear operation was operated after when there was an error in reading registration marks.
  5. Fixed the problem that cutting motion starts again when stopping the job and clearing the buffer under wireless LAN connection.
  6. Fixed the problem that [QUIT COPY] could not be selected when copying with [MEDIA CHANGE MODE] turned ON.
  7. Revised the Spanish text on the IP address setting menu.

Ver.1.02

  1. Fixed the problem that a scanning error occurs when printing Mask around registration marks.
  2. Fixed the problem that a value exceeding the maximum value was displayed in Expand Settings.
  3. Fixed the problem where the keys become unresponsive after operating continuous cutting with sheet media.
  4. Fixed the problem where the keys become unresponsive after operating continuous cutting with roll media.
  5. Fixed the problem that the tool did not move back to the start position, when [Scanning start position of Registration Marks] was selected in Cutting Master 5 and Graphtec Studio 2 and scanning error occurred.